Introduction:
Drain clogs are a common problem in modern households. These can range from minor to severe, depending on how long they have been there and what was causing them. There are many different reasons why your drain may be clogged, but most of the time, a plunger can save you thousands.
Using an old-fashioned plunger will save you thousands. You can find these at any hardware store or home improvement store near you, so if this doesn’t work then you can use one of the other methods below. The steps to clearing a drain with a plunger are as follows:
Steps:
#1 Get an old-fashioned rubber plunger and make sure there is enough water in the sink so that when you place it over top of the drain, it covers the entire hole. Place your hands on either side of the plunger and push down hard into the drain while rotating counterclockwise at least six times. Make sure that you have a firm grip on each side of the plunger! If this doesn’t work, try pushing twice as fast. This should be able to clear out most clogs if done right.
#2 Wire Hanger or Plumbing Snake – In some cases plunging may not be able to clear out a clog, or you might have already tried this method and it still does not work. It’s pretty simple. Take a wire hanger and straighten it out completely so that there is no wave at the end of it. Once this is done, pull back on each side until it bends into a U-shape. After you do this, bend one end of the wire outward until you have created a brush at the end of your wire. Make sure that this brush has lots of little bristles so that they can catch onto any foreign objects causing your clog. Start by inserting the wire hanger straight down the drain, slowly rotating it to loosen up any debris or grime that may be stuck inside. You can also move it back and forth for this same effect if you need to! If these steps do not work, then run a plumber snake through the drain instead to clear out any kind of blockage. These are available at most hardware stores as well, so they should be easy to come by.
#3 Calling a Plumber – Lastly, if the first two methods did not fix your problem then you should consider calling a plumber because without their help there is no way to properly provide you with an effective solution for clearing out your drain! You can call a local plumbing contractor and they will be able to help you. Please note that plumbers charge by the hour, so it is best not to wait until your drain is completely clogged before calling them out because of this! It may also take some time for them to clear the drain once they show up, so understand that there might be a bit of a wait involved if you decide to go this route.
Conclusion:
You should try all three methods listed above before calling a plumber because at least one of them should work. Remember: Plunging works on most standard kitchen and bathroom sink drains but it will not work on every single type of clog or design. You may want to consider using another method first if plunging does not work. Thank you for reading and feel free to share this article with others who may be in need!
